Glass guide
Toughened safety glass: what ESG means
In German glazing, ESG stands for Einscheiben-Sicherheitsglas: single-pane toughened safety glass. Glass showers and all-glass doors, among other things, are made from it. Knowing how it is made also explains why every dimension and every hole must be fixed before made-to-measure glass is produced. (This is not about ESG in the sense of environmental, social and governance criteria – that is covered in the guide on ESG and sustainability with glass in commercial properties.)
How toughened glass is made
The starting material is ordinary float glass. It is first cut to size, edge-worked and drilled. The pane is then heated to over 600 °C and rapidly cooled with air. This creates compressive stress at the surface and tensile stress in the core. This pre-stressing makes the glass considerably more resilient.
What toughened glass offers
Compared with ordinary glass, toughening brings three advantages.
- Higher bending strength: EN 12150-1 specifies 120 N/mm² for toughened safety glass; ordinary float glass is rated at 45 N/mm².
- Higher resistance to temperature changes, around 200 kelvin
- If it breaks, the pane shatters into small, blunt-edged fragments instead of large, sharp shards
Why nothing can be changed afterwards
Once toughened, the glass can no longer be cut, drilled or ground. Any intervention would release the stress in the glass and make the pane shatter. That is why dimensions, holes for fittings and cut-outs are fixed before production. An accurate on-site survey is therefore not a formality for made-to-measure glass, but a prerequisite.
How to recognise it
Toughened safety glass is usually marked with a permanent stamp in one corner. It shows the manufacturer or its mark and the standard EN 12150. For all-glass installations the stamp is sometimes omitted for visual reasons; the manufacturer's documents then provide the information.
Heat-soaked and laminated glass
Very rarely, toughened glass can break without any external cause, triggered by tiny nickel sulphide inclusions. For facades and other applications with special requirements there is therefore heat-soaked toughened glass (ESG-H): the panes undergo a heat soak test according to EN 14179, which significantly reduces this risk. Laminated safety glass (VSG) consists of at least two panes bonded with a tough interlayer; if it breaks, the fragments stick to the interlayer. Which type of glass makes sense or is required where depends on the application and is clarified during planning.
Toughened glass in showers, doors and wall panels
Glass showers are made from safety glass; the standard for shower enclosures, EN 14428, sets requirements for the glass and its fixing. Glass thicknesses of 6 or 8 mm are common, depending on size, design and fittings. All-glass doors are also usually made of toughened glass. For glass wall panels, the type of glass depends on where they are used and on heat exposure, for example behind a hob.
Questions for your enquiry
- Where will the glass be used: shower, door, partition or wall panel?
- Are there holes, cut-outs or sockets that need to be planned in?
- Photos and rough measurements of the installation situation